How do you fit your WatchCare protection at home?

In this tutorial, you'll find all the steps and tips you need to install your WatchCare protection kit at home.

Step 1: Get your WatchCare protection kit.

Discover its contents: your kit protected by an envelope, our cleaning solution, the microfibre and the pliers. All these items will be needed to fit your kit.

Cleaning Solution

Use this solution to clean and disinfect your watch and prepare it for the protective kit.

Microfiber

Use this microfibre cloth to dry your watch after cleaning. It can also be used to wipe off excess water after fitting.

The fabric composition prevents micro-scratches.

Application tweezers

Use these antistatic pliers to install your protection kit, using a material that will not damage your watch during installation.

Protective Kit

You'll find your ready-to-use protective kit in this pouch, with a QR code on the back to take you to this installation tutorial.

Step 2: Clean your watch with the cleaning solution and the microfibre cloth.

Apply a little cleaning solution to the watch and rub with the microfibre to remove all the dirt and dust from your watch.

Be sure to dry the watch thoroughly with the microfibre so that no cleaning solution remains on the watch before applying the protective film.

You can also clean your watch with clear water and soap, provided it is water-resistant.

Step 3: Prepare a bowl filled with clear water to make it easier to fit the protection kit.

Step 4: Take the WatchCare protection kit from the protective pouch.

Using the pliers supplied in the kit, carefully remove the part you wish to fit to your watch from the WatchCare module.

We advise you to hold it in a corner so that you are not obstructed during installation.

Step 5: Partially immerse the piece you are going to place in your bowl filled with clear water.

Immersing the part in water will help you to get back on track if the part has not been laid properly, but it will also improve the transparency and adhesion of the protection kit.

To avoid any deposits under your protection kit, make sure you use clean, clear water.

Step 6: Place the protective part on your watch.

Carefully place the piece on your watch, making sure that it does not protrude over any edge of the watch.

Once the piece is in place, press gently with the microfibre to remove excess water and secure the piece to the watch.

Step 7: Leave the protection kit to dry for at least 48 hours to ensure maximum adhesion and transparency.

We know it's going to be tough, but we advise you not to wear your watch for 48 hours after fitting your protection kit.

All you have to do is enjoy your watch every day without worrying about its wear!